Offline Downgrade/Upgrade
Prerequisites:
--SD card
--Unplug any Gamecube Memory Cards, Gamecube Controllers, USB Devices
--Read the FAQ and be prepared with a general knowledge of Wii Homebrew
http://www.mediafire.com/?q2iy0zgz2my (07-22-2009)
This package contains instructions on how to acquire the necessary files from Nintendo to do an offline update
This package will work on ANY Wii! Virgin or Nintendo Official Updated without cios!!
1) Extract the files somewhere on your hard drive such as C:\wii\ and run prepare.bat and choose your desired version
2) Check that the WAD files are correct with MooSFV. If any files are not correct run clean.bat and start over
3) Format your SD card to FAT16. Copy the contents inside the sd folder to the root of your SD card
4) Insert the SD card in the Wii and go to Data Management>Channels>SD Card press YES on the dialog box that asks to load boot.dol
5) Install the Homebrew Channel and install BootMii as boot2 if possible or as an IOS if boot2 is not available.
6) Launch Bootmii (if you installed to boot2 just reset the system if you installed to IOS go to the HBC and press the Home button)
7) Open the config menu (gears) and choose backup NAND (green arrow) wait for it to finish and restart the Wii
8) Run Trucha Bug Restorer and choose "IOS36" and pick "Downgrade IOS15" and "Load IOS from sd card" then restart
9) Run Trucha Bug Restorer again and choose "IOS15" then "IOS36 menu" set "IOS to slot 36" and "yes" "yes" "yes" to the 3 options then press "Install patched IOS36" and "Load IOS from sd card"
10) Run cIOS36_rev10-Installer and choose WAD Installation
11) Run WAD-Manager_v1.4 again. Choose IOS249 and install WADs 01-18. If WAD Manager freezes during installation just try again from the WAD it froze on.
12) While still in WAD Manager install SystemMenuv###.wad
13) It is highly recommended that you install preloader to prevent bricks. On the install screen press 1
14) Hold reset while powering on to access preloader and set preloader settings. In preloader hacks enable "Skip disc update check"
Source: GBAtemp
Firmware Updater 4.1 này dùng cho máy hệ nào vậy bạn? máy hệ J update lên có bị brick không?SM 4.1 ra được mấy hôm rồi. Mọi người thử upgrade xem sao. Rồi cho ý kiến lun
Theo Wiibrew thì nên cài HBC trước rồi mới up:
Sau đây là link down Firmware Updater 4.1 của Waninkoko:
Mọi người giải nén, cài đặt bằng HBC. Mọi thứ sẽ automatic hết (yêu cầu kết nối wifi). Sau đây là nguyên văn trên blog của bác Wan:
P/S: Mình cũng chưa thử nữa (máy đang brick ), Vodoi, Chanh hay anh Bảo test thử xem, nếu được thì em sẽ post ra ngoài
Bạn để ý mà coi gói offline cũng có cài preloader mà Wii J và KOREA đâu cài được preloader.This is the ULTIMATE Tutorial for everything you need for System Menu 4.1
for EUR and USA Wiis only not JAP or KOREAN
trong phần giới thiệu có nói đến gói offline(gói offline tìm ở đầu trang 29) ở đây mình chỉ trích gói online.Trong gói dowload trên có sẵn hack.ini để cài preloader nhưng thiếu hack.ini 4.1 EUR.Bạn nào có Wii EUR thì lấy hack.ini 4.1 EUR ở đây:This is the ULTIMATE Tutorial for everything you need for System Menu 4.1
for EUR and USA Wiis only not JAP or KOREAN
There are two methods described in this guide. Online and completely Offline installations. The Online installation is the safer method. They should both work on ANY Wii besides LU64+. You only need to use one guide, they both do the same thing. Please read the entire thread including FAQ before asking a question.
Online Downgrade/Upgrade
Prerequisites:
--SD card
--Wifi Connection (Ethernet doesnt work)
--Unplug any Gamecube Memory Cards, Gamecube Controllers, USB Devices
--Read the FAQ and be prepared with a general knowledge of Wii Homebrew
http://www.mediafire.com/?ntzzmuywymt (07-22-09)
1) Format your SD card to FAT16. Copy the contents inside the sd folder to the root of your SD card
2) Insert the SD card in the Wii and go to Data Management>Channels>SD Card press YES on the dialog box that asks to load boot.dol
3) Install the Homebrew Channel and install BootMii as boot2 if possible or as an IOS if boot2 is not available.
4) Launch Bootmii (if you installed to boot2 just reset the system if you installed to IOS go to the HBC and press the Home button)
5) Open the config menu (gears) and choose backup NAND (green arrow) wait for it to finish and restart the Wii
6) Run Trucha Bug Restorer and choose "IOS36" and pick "Downgrade IOS15" and "Download IOS from NUS" then restart
7) Run Trucha Bug Restorer again and choose "IOS15" then "IOS36 menu" set "IOS to slot 36" and "yes" "yes" "yes" to the 3 options then press "Install patched IOS36" and "Download IOS from NUS"
8) Install cIOS36 rev10 to IOS249 using Network install mode
9) Downgrade system IOS files using IOS Downgrader
10) Downgrade to 3.2 using cIOS Downgrader even if you are already on 3.2 run this
11) Run 4.1 Firmware-Updater.
12) Using Dop-IOS install IOS60 v6174 with Sig Hash Check.
13) Install preloader. On the install screen press 1
14) Set your preloader settings. In preloader hacks enable "Skip disc update check"
vì vậy vấn đề có chút mâu thuẫn ở đây.Vậy kính mong bà con có Wii JAP up xong thông báo cho một câu để cởi bỏ ách tắc.Nhưng có Bootmi boot2 thì nhớ làm cái backup trước.Thực sự mình chỉ muốn có sự thận trọng mà thôi,hy vọng những băn khoăn của mình là sai.This is the ULTIMATE Tutorial for everything you need for System Menu 4.1
for EUR and USA Wiis only not JAP or KOREAN
There are two methods described in this guide. Online and completely Offline installations. The Online installation is the safer method. They should both work on ANY Wii besides LU64+. You only need to use one guide, they both do the same thing. Please read the entire thread including FAQ before asking a question.